LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2006 >> Commander Base, 4.7 N, RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) >> Electronic Control Modules >> Standard Procedure >> Standard Procedure - Pcm/ECM/SKREEM Programming >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Standard Procedure - Pcm/ECM/SKREEM Programming: Notes

NOTE: Before replacing the Powertrain Control Module (PCM) or Engine Control Module (ECM), be certain to check the related component/circuit integrity for failures not detected due to a double fault in the circuit. Most PCM/ECM driver/control circuit failures are caused by internal component failures (such as relays and solenoids) and shorted circuits (such as pull-ups, drivers, and switched circuits). These failures are difficult to detect when a double fault has occurred and only one DTC has been set.

When a PCM, or ECM, and the Sentry Key Remote Entry Module (SKREEM) on vehicles equipped with the Sentry Key Immobilizer System (SKIS) are replaced at the same time, perform the following steps in order:

  1. Program the new PCM or ECM.
  2. Program the new SKREEM (also known as the Wireless Control Module/WCM).
  3. Replace all ignition keys and program them into the new SKREEM/WCM.
scientia non olet · About LEMON Manuals