Module-Final Drive Control: Operation: Inputs/Outputs
The following are inputs to the FDCM:
- Lateral Accelerometer
- Transfer Case Range Select Switch
- Transfer Case Mode Sensor Signal
- Front Differential Temperature Sensor
- Rear Differential Temperature Sensor
- 3 Direct Battery Feeds
- Ignition RUN Sense
- Sensor Grounds
- Module Grounds
- CAN C Bus
The following are outputs of the FDCM:
- 5V Sensor Supply
- Transfer Case NEUTRAL Lamp
- Front Electronic Limited Slip Differential Pressure Solenoid
- Rear Electronic Limited Slip Differential Pressure Solenoid
- Transfer Case Bi-directional Motor Control (A & B)
- Switched B+ Solenoid Supply
- Transfer Case Motor Brake Control