LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2006 >> Commander Base, 4.7 N, RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) >> Module-Front Control >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module-Front Control: Removal

Fig 1: Removing/Installing Front Control Module
GC0027614Courtesy of DAIMLERCHRYSLER CORP.
CAUTION: Front Control Module (FCM) damage may occur if the module case comes in contact with the battery while still connected. Always disconnect the battery negative cable prior to removal of the FCM.
  1. Disconnect and isolate the battery negative cable.
  2. Remove the Integrated Power Module (IPM) from the engine compartment, (Refer to ELECTRICAL/POWER DISTRIBUTION/INTEGRATED POWER MODULE - REMOVAL) .
  3. Remove the four fasteners (2) securing the Front Control Module (FCM) (1) to the IPM (3).
  4. Separate the FCM from the IPM by pulling the two straight away from each other to disengage the electrical connector.
scientia non olet · About LEMON Manuals