Button Operation

The Compass/Temp Mirror incorporates 3 (mode/lamp) buttons to access and control various functions.

Left Button

Press and Release
- > Toggles Left Map Light On/Off
Press w/Right Switch for more than 5 seconds and Release
- > Toggles Electrochromic Status On/Off - automatic On with each ignition cycle
- > On mode is indicated by green status LED next to right button

Center Button

Press for more than 3 seconds and Release
- > Cycle through display status
  - Compass / Temperature (Fahrenheit) - °F mode stored to memory
  - Compass / Temperature (Celsius) - °C mode stored to memory
  - Display Off - off mode stored to memory
Press and Hold for 3-6 seconds
- > Activate zone variance mode (adjust compass for true north)
  - "Z" and the currently programmed zone (1-15) will flash in display window
  - Each press of the center button will increment to the next zone
  - When proper zone is selected, wait 5 seconds and mirror display returns to comp/temp (see variance zone map for proper zone number setting)
Press and Hold for more than 6 seconds
- > Activate compass calibration
  - "CAL" shows in display window until compass is calibrated (verify correct variance zone prior to initial or re-calibration)
  - Drive vehicle in a slow circle for 1.5 revolutions to recalibrate compass

Right Button