LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2007 >> Commander Base, 4.7 P, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (3.7L Engine (Service Information)) >> Lubrication >> Sensor/Switch-Oil Pressure >> Removal >> Oil Pressure Sensor/Switch
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Oil Pressure Sensor/Switch

WARNING: This page is about a different variant/trim than selected.
Fig 1: Oil Pressure Sending Unit
GC0011823Courtesy of CHRYSLER LLC
  1. Disconnect the negative cable from the battery.
  2. Raise vehicle on hoist.
  3. Remove front splash shield.
  4. Disconnect oil pressure switch connector (4).
  5. Remove the pressure switch (2).
scientia non olet · About LEMON Manuals