Front Wiper Module
- Disconnect and isolate the battery negative cable.
- Remove both front wiper arms from the wiper pivots. See REMOVAL .
- Remove the cowl plenum cover/grille panel from over the front wiper module. Refer to REMOVAL .
- Disengage the routing clip from the stud in the cowl plenum and disconnect the wire harness (1) connector (2) from the connector receptacle for the front wiper motor (3).
- Remove the two screws (2) that secure the ends of the front wiper module bracket (3) to the stamped brackets (1) within the cowl plenum.
- Pull the front wiper module inboard far enough to disengage the knob-like rubber isolator from the slotted bracket (4) on the forward wall of the cowl plenum.
- Remove the front wiper module from the cowl plenum as a unit.