Rear Wheel Speed Sensor - Front-Wheel-Drive

NOTE: Before proceeding, refer to WARNING . and CAUTION .

Fig 1: REAR FLOOR PAN SILENCER

Courtesy of CHRYSLER LLC

Remove the cargo floor cover.
Remove the rear floor pan silencer (1).

Fig 2: RADIO RECEIVER AND AMPLIFIER
Courtesy of CHRYSLER LLC
If equipped, remove the nuts mounting the satellite receiver (1) or amplifier (2) to rear floor pan. Move the component aside to allow access to the wheel speed sensor wiring connector through the opening in bottom of the quarter trim panel.

Fig 3: REAR WSS AT HARNESS CONNECTOR
Courtesy of CHRYSLER LLC
Through the opening in the bottom of the quarter trim panel, disconnect the wheel speed sensor cable connector (2) at the body wiring harness connector (3).
Raise and support the vehicle. Refer to STANDARD PROCEDURE .

Fig 4: TIRE AND WHEEL MOUNTING
Courtesy of CHRYSLER LLC
Remove the wheel mounting nuts (3), then the rear tire and wheel assembly (1).

Fig 5: REAR WSS MOUNTING TO BODY
Courtesy of CHRYSLER LLC
Remove the grommet (2) from the hole in the body (1) and pull the wheel speed sensor cable out through the hole.
Remove the speed sensor cable routing clip (3) from the outside frame rail (4).

Fig 6: SENSOR MOUNTING TO REAR CROSSMEMBER
Courtesy of CHRYSLER LLC
Remove the screw (1) fastening the cable routing clamp (3) to the rear suspension crossmember (4).

Fig 7: REAR WHEEL SPEED SENSOR MOUNTING TO TRAILING LINK
Courtesy of CHRYSLER LLC
Remove the speed sensor cable routing clip (1) from the trailing link (2).
Remove the screw (4) fastening the cable routing clamp to the trailing link.

Fig 8: FWD REAR WHEEL SPEED SENSOR AT HUB AND BEARING
Courtesy of CHRYSLER LLC
Remove the screw (1) fastening the wheel speed sensor head (3) in the rear of the hub and bearing (2). Remove the sensor from the vehicle.