Tire Pressure Sensor Retraining

The TPMS automatically learns and stores the sensor's ID while driving after a sensor has been replaced. There is no formal retraining procedure necessary. Drive vehicle for a minimum of 10 minutes while maintaining a continuous speed above 20 mph (32 km/h). During this time, the system will learn the new sensor ID code and will clear any DTCs automatically. If a sensor cannot be trained, see appropriate manufacturer service information.

The sensor IDs can also be programmed using the TPM-RKE Analyzer Tool. Scan each TPM sensor at each road wheel, and store each Sensor ID in the correct location. (LEFT FRONT, LEFT REAR, RIGHT FRONT, and RIGHT REAR) Connect the TPM-RKE Analyzer Tool to the Scan Tool. Then follow the programming steps outlined in the diagnostic Scan Tool for "Program Tire Pressure Sensor ID w/ TPM Tool". Once the new sensor ID has been programmed, the vehicle will need to be driven above 20 mph until the fault is no longer active (lamp extinguishes) and display is updated (for up to 20 minutes).