Installation

INSTALLATION

NOTE: If the ABM module (1) is being replaced with a new ABM module it must be reprogrammed with the use of a scan tool.




1. Install ABM module (1) to the ABM unit (3).

2. Install mounting screws (2). Tighten to 2 Nm (16 in. lbs.).




3. Install the ABM unit (2) to the vehicle.

4. Install the ABM mounting bracket nuts (3) and tighten to 14 Nm (125 in. lbs.).

5. Install brake lines (1) to the ABM unit (2) and tighten to 20 Nm (180 in. lbs.).




6. Install the wiring harness connector (4) to the ABM unit and push down on the release to secure the connector.

7. Install negative battery cable to the battery.

8. Bleed ABS brake system.