Fuel Tank Module
CAUTION:
Whenever the fuel pump module is serviced, the rubber seal (gasket) must be replaced.
| 1 - 1/2" BREAKER BAR |
| 2 - TOP OF FUEL TANK (TYPICAL) |
| 3 - SPECIAL TOOL #9340 |
| 4 - FUEL TANK MODULE (TYPICAL) |
| 5 - MODULE LOCK RING |
- Using a new seal (gasket), position fuel tank module into opening in fuel tank.
- Position lockring (5) over top of fuel pump module. See Fig 1.
- Rotate module until embossed alignment arrow points to center alignment mark. This step must be performed to prevent float from contacting side of fuel tank. Also be sure fuel fitting on top of pump module is pointed to front of vehicle.
- Install Special Tool 9340 (3) to lockring.
- Install 1/2 inch drive breaker (1) into Special Tool 9340 (3).
- Tighten lockring (clockwise) until all seven notches have engaged.
- Install fuel tank. Refer to Fuel Tank Removal/Installation.