Programming The SKREEM/WCM Using The Scan Tool

STANDARD PROCEDURE - PROGRAMMING THE SKREEM/WCM USING THE SCAN TOOL

CAUTION: Read all notes and cautions for programming procedures.

1. Connect a battery charger to the vehicle.

2. Connect the scan tool.

CAUTION: If the ECM/PCM and SKREEM/WCM are replaced at the same time, the ECM/PCM MUST be programmed before the SKREEM/WCM.

3. Select "ECU View".

4. Select "WCM Wireless Control Module".

5. Select "Miscellaneous Functions".

6. Select WCM replaced.

7. Enter the PIN when prompted.

8. Verify the correct information.