LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2007 >> Wrangler X, Standard >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Vehicle Theft Security System (Service Information) >> Vehicle Theft Security >> Intrusion Module - Export >> Removal >> Intrusion Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Intrusion Module

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, airbag, occupant classification system, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.
Fig 1: Identifying Intrusion Module Components
GC0064098Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the steering column opening cover from the instrument panel. Refer to REMOVAL .
  3. Remove the two screws (1) that secure the intrusion module mounting bracket (4) to the lower instrument panel reinforcement (2).
  4. Lower the intrusion module (3) and mounting bracket from the instrument panel reinforcement far enough to access and disconnect the instrument panel wire harness connector from the connector receptacle at the forward-facing end of the module housing.
  5. Remove the module and mounting bracket from under the instrument panel as a unit.
scientia non olet · About LEMON Manuals