Quick Learn - 4.7L/5.7L Vehicles

The quick learn procedure requires the use of the scan tool.

This program allows the electronic transmission system to re-calibrate itself. This will provide the proper transmission operation. The quick learn procedure should be performed if any of the following procedures are performed:

• Transmission Assembly Replacement
• Transmission Control Module Replacement
• Solenoid Pack Replacement
• Clutch Plate and/or Seal Replacement
• Valve Body Replacement or Recondition

To perform the Quick Learn Procedure, the following conditions must be met:

• The brakes must be applied
• The engine speed must be above 500 RPM
• The throttle angle (TPS) must be less than 3 degrees
• The shift lever position must stay in PARK until prompted to shift to overdrive
• The shift lever position must stay in overdrive after the Shift to Overdrive prompt until the scan tool indicates the procedure is complete
• The calculated oil temperature must be above 15.5°C (60°F) and below 93°C (200°F)