Fuel Pump Module

WARNING: This page is about a different car, the 2008 Jeep Commander. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: The fuel system is under a constant pressure (even with the engine off). Before servicing the fuel pump module, the fuel system pressure must be released. See STANDARD PROCEDURE .

Fig 1: Fuel Pump Module Location

Courtesy of CHRYSLER LLC

Drain and remove fuel tank. See REMOVAL .
Note rotational position of module before attempting removal. An indexing arrow is located on top of module for this purpose.
Position Lockring Remover/Installer 9340 (3) into notches on outside edge of lockring (5).
Install 1/2 inch drive breaker bar (1) to tool 9340 (3).
Rotate breaker bar counter-clockwise to remove lockring.
Remove lockring. The module will spring up slightly when lockring is removed.
Remove module from fuel tank. Be careful not to bend float arm while removing.