Fuel Level Sending Unit Sensor

WARNING: This page is about a different car, the 2008 Jeep Commander. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Fuel Level Sending Unit

Courtesy of CHRYSLER LLC

The fuel level sending unit (fuel level sensor) (3) and float assembly (7) and (8) is located on the side of the fuel pump module.

Remove fuel pump module from fuel tank. See REMOVAL .
Disconnect electrical connector from fuel pump module. Record pin location first. Separate necessary sending unit wiring from connector using terminal pick/removal tool.
To remove sending unit from pump module, use a small pick (5) or screwdriver. Lift on plastic locking tab (4) while sliding sending unit (3) down the mounting tracks (6).