Diagnostic Test

CHECK TO SEE IF THE DTC IS ACTIVE
1. With the scan tool, read Transmission DTCs.
  Is the status Active or is the Starts Since Set counter 2 or less for this DTC?
  
  Yes
  - Go To 2.
  No
  - Go To 5.

CHECK THE TRS READINGS ON THE SCAN TOOL

SHIFT LEVER POSITION TO TRS SWITCH STATE
PARK	REVERSE	NEUTRAL	DRIVE	LOW
T41 CLOSED	T42 CLOSED	T4 CLOSED	T3 CLOSED	T1 CLOSED

Ignition on, engine not running.
With the scan tool, read the TRS states while moving the shift lever to all positions note any circuits may close at the same time.
NOTE:
Vehicles equipped with the AutoStick feature will not have a low range shift position.

Did one or more than one TRS Sense circuit show being closed at the same time?

Yes
- Go To 3.
No
- Check the Shift Lever Cable for proper adjustment and binding in accordance with the Service Information. If no problems are found, using the schematics as a guide, check the Transmission Control Module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. Check for any Service Bulletins for possible causes that may apply. If again no problems are found, replace the TCM in accordance with the Service Information
- Perform CVT VERIFICATION TEST. Refer to Standard Procedure .

CHECK THE TRS SENSE CIRCUIT FOR A SHORT TO VOLTAGE
1. Turn the ignition off to the lock position.
2. Disconnect the TRS harness connector.
  NOTE:
  The possibility of erroneous DTCs may set due to disconnection of the TRS harness connector. Disregard any additional DTCs that may set.
4. Ignition on, engine not running.
5. Using the scan tool, read the TRS Sense circuit states.
  Do any of the TRS Sense circuits read closed?
  
  Yes
  - Repair the identified TRS Sense circuit for a short to voltage.
  - Perform CVT VERIFICATION TEST. Refer to Standard Procedure .
  No
  - Go To 4.
CHECK THE TRS SENSE CIRCUIT FOR A SHORT TO ANOTHER TRS SENSE CIRCUIT
1. Turn the ignition off to the lock position.
2. Disconnect the TCM C1 and C2 harness connectors.
4. Measure the resistance between the two identified TRS Sense circuits in the second step.
  Is the resistance below 5.0 ohms?
  
  Yes
  - Repair the identified TRS Sense circuits for a short to each other.
  - Perform CVT VERIFICATION TEST. Refer to Standard Procedure .
  No
  - Replace the TRS Assembly in accordance with the Service Information.
  - Perform CVT VERIFICATION TEST. Refer to Standard Procedure .
CHECK THE WIRING AND CONNECTORS
1. The conditions necessary to set this DTC are not present at this time.
2. Using the schematics as a guide, inspect the wiring and connectors specific to this circuit.
3. Wiggle the wires while checking for shorted and open circuits.
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform CVT VERIFICATION TEST. Refer to Standard Procedure .
  No
  - Test Complete.