Section 196 (Front Axle): Installation: Installation

WARNING: This page is about a different car, the 2012 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Front Axle

Courtesy of CHRYSLER GROUP, LLC

Install front axle assembly (1) into position. Refer to Fig 1. Install and tighten axle housing-to-engine bolts to 65 N.m (48 ft. lbs.).

Fig 2: Power Steering Return Line & Clips
Courtesy of CHRYSLER GROUP, LLC
Install power steering return line to cradle by fastening clips (1).

Fig 3: Front Drive Axle Housing Support Bracket
Courtesy of CHRYSLER GROUP, LLC
Install axle assembly support bracket (1) and torque bolts to 28 N.m (21 ft. lbs.). Refer to Fig 3.
Install RH catalytic converter/exhaust pipe assembly. Refer to CONVERTER, CATALYTIC, INSTALLATION .
Install front propeller shaft. Refer to INSTALLATION .
Install intermediate shaft. Refer to INSTALLATION .
Install both front halfshafts. Refer to INSTALLATION .

Fig 4: Fill Plug
Courtesy of CHRYSLER GROUP, LLC
Fill axle with 600ml (0.64 qts.) of Mopar® 75W-90 Synthetic Gear Lubricant. Fluid level should be at or near bottom of fill hole. Torque fill plug (1) to 30 N.m (22 ft. lbs.). Refer to Fig 4.
Lower vehicle.