Erasing HOMELINK® Transceiver Codes
WARNING: This page is about a different car, the 2012 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Individual channels cannot be erased. Erasing the HomeLink® transceiver codes will erase ALL programmed codes.
To erase programming from all three buttons (individual buttons cannot be erased but can be reprogrammed), press and hold the two outer HomeLink® transceiver buttons until the indicator light begins to flash after about 20 seconds. Release both buttons. Do not hold for longer that 30 seconds. HomeLink® is now in the train (or learning) mode and can be programmed at any time beginning with Programming. Refer to STANDARD PROCEDURE .