MODULE, Fuel Pump: Installation: Installation
WARNING: This page is about a different car, the 2009 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Whenever the fuel pump module is serviced, the rubber O-ring seal must be replaced.
- Using a new seal (gasket), position fuel pump module into opening in fuel tank.
- Position lock ring (5) over top of fuel pump module.
- Rotate module until embossed alignment arrow points to center alignment mark. This step must be performed to prevent float from contacting side of fuel tank.
- Install Lock ring Remover/Installer 9340 (3) to lock ring.
- Install 1/2 inch drive breaker (1) into Lockring Remover/Installer 9340 (3).
- Tighten lockring (clockwise) until all seven notches have engaged.
- Install fuel tank.