Weld Process
WARNING: This page is about a different car, the 2012 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
| COMPONENT PARTS | TRUCK FRAME | BODYSHELL EXTERIOR & UNDERBODY PANELS | ||||
|---|---|---|---|---|---|---|
| Zinc and Zinc Iron Alloy coated sheet steels | ||||||
| WELDING PROCESS | GAS METAL ARC (Note: 1) |
FLUX CORED ARC | GAS METAL ARC (Note: 1) |
MIG BRAZE (Note: 2) |
GAS METAL ARC (Note: 1) |
FLUX CORED ARC |
| Material Type | High Strength and Structural Quality Steels which includes HSLA, Martensitic, and Dual Phase materials | |||||
| Material Thickness Range | 2 mm - 4 mm | 0.6 mm - 1.02 mm | >1.02 mm - 3.0 mm | |||
| ELECTRODE TYPE (AWS SPEC. A5.18) |
AWS CLASS. ER70S-6 | AWS CLASS. E71T-11 (Note 3) |
AWS CLASS. ER70S-6 | AWS CLASS. ERCuSi - A Silicon Bronze | AWS CLASS. ER70S-6 | AWS CLASS. E71T-11 (Note 3) |
| ELECTRODE SIZE | 0.035 | 0.045 | 0.023 - 0.025 | 0.035 | 0.035 | 0.045 |
| ELECTRODE MAKER | Lincoln® | Lincoln® NR-211-MP |
Lincoln® | Lincoln® | Lincoln® NR-211-MP |
|
| WIRE FEED SPEED (in/min) | 245-250 Vertical Down | 110 Vertical Down | 95-115 All Welds | 150-155 Flat & Horizontal | 245-250 Vertical Down | 110 Vertical Down |
| 70-90 Flat & Horizontal | 70-90 Flat & Horizontal | 70-90 Flat & Horizontal | 70-90 Flat & Horizontal | |||
| TRAVEL SPEED (in/min) | 10 | |||||
| VOLTAGE | 19-20 | 15-18 | 16-19 | 18-19 | 19-20 | 15-18 |
| POLARITY | DCEP | DCEN | DCEP | DCEP | DCEP | DCEN |
| GAS FLOW (cfh) | 25-35 | N/A | 25-35 | 25-35 | 25-35 | N/A |
| ELECTRICAL STICKOUT (in) | 1/2 - 5/8 | 3/8 - 1/2 | 1/2 - 5/8 | 5/8 - 3/4 | 1/2- 5/8 | 3/8 - 1/2 |
| GAS TYPE | 75% Ar | N/A | 75% Ar | 100% Ar | 75% Ar | N/A |
| 25% CO2 | 25% CO2 | 25% CO2 | ||||
| TYPE OF ARC TRANSFER | Short Circuit | Short Circuit | Pulse | Short Circuit | ||
These Procedure Specifications are appropriate as of this publication. Procedures may be superseded with new spec's at a later date.
Always process to the thinner material thickness (TMT)
All persons performing welding must be qualified to weld in all positions.
NOTE:
- Must remove Zinc Coating on both sides of metal at the weld zone.
- MIG Braze welding process requires use of Pulse Arc® or STT® welding machine.
- Must use Lincoln® product since E 71T-11 product differs from other suppliers.