Section 383 (Propeller Shaft): Installation: Front

WARNING: This page is about a different car, the 2015 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Propeller Shaft Removal/Installation

Courtesy of CHRYSLER GROUP, LLC

Install propeller shaft (1) into position.
NOTE:
Drive shaft bolts must be replaced with NEW or cleaned and Mopar® Lock and Seal Adhesive or equivalent applied.
Starting at transfer case end, align index marks placed upon removal and loose-install propeller shaft-to-transfer case flange bolts.
Align index marks at front axle end of shaft, and loose-install propeller shaft-to-front axle flange bolts.
Torque propeller shaft-to-transfer case and axle flange bolts (2) to the proper specification. Refer to SPECIFICATIONS .

Fig 2: Removing/Installing Heat Shield
Courtesy of CHRYSLER GROUP, LLC
Install propeller shaft heat shield (1).
Remove the support and lower the vehicle.