MODULE, Final Drive Control: Removal: Removal

WARNING: This page is about a different car, the 2009 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The FDCM has two electrical connectors and is installed inside the passenger compartment behind the driver side knee bolster and is mounted to the left kick panel. On RHD vehicles the FDCM is located in a mirrored position on the right side.

Fig 1: FINAL DRIVE CONTROL MODULE

Courtesy of CHRYSLER LLC

Lower the drivers side knee bolster.
Push out on the two locking tabs (1) and remove the FDCM.

Fig 2: FDCM ELECTRICAL CONNECTORS
Courtesy of CHRYSLER LLC
Disconnect the two electrical connectors (1) from the FDCM.