Module, Body Control: Removal: Removal: Procedure

WARNING: This page is about a different car, the 2012 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Glove Box Assembly & Push Panel

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the negative battery cable.
Remove the glove box assembly (1). Refer to GLOVE BOX, INSTRUMENT PANEL, REMOVAL .
Remove the Instrument Panel (IP) lower hush panel (3).

Fig 2: Body Control Module (BCM), Receptacles & Fasteners
Courtesy of CHRYSLER GROUP, LLC
Disconnect the electrical connectors from the Body Control Module (BCM) (1) receptacles (2 and 3) as needed.
Remove the fasteners (4) that secure the module, two at the bottom, and one at the top.
Pull the module away from the side bulk head and down and remove the module.
Remove the BCM from the vehicle.