Module, Powertrain Control: Removal: Gas

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: PCM & Connectors

Courtesy of CHRYSLER GROUP, LLC

NOTE:

USE THE SCAN TOOL TO REPROGRAM THE NEW POWERTRAIN CONTROL MODULE (PCM) WITH THE VEHICLES ORIGINAL IDENTIFICATION NUMBER (VIN) AND THE VEHICLES ORIGINAL MILEAGE. IF THIS STEP IS NOT DONE, A DIAGNOSTIC TROUBLE CODE (DTC) MAY BE SET.

To avoid possible voltage spike damage to PCM, ignition key must be off, and the negative battery cable must be disconnected before unplugging the PCM connectors.

Disconnect and isolate the negative battery cable.
Unlock and disconnect the 2 electrical connectors (1) at the PCM (2).

Fig 2: PCM, Connectors & Bracket
Courtesy of CHRYSLER GROUP, LLC
Remove the 4 bolts (3) holding the PCM (2) to the bracket (1) and remove the PCM (2) from the vehicle.