Tire Pressure Sensor Retraining

Using a RF signal, each sensor transmits tire pressure data approximately once every minute. Each sensor's (transmitter) broadcast is uniquely coded so that the TPM module can monitor the state of each of the sensors on the 4 rotating road wheels. The TPM module automatically learns and stores the sensor's ID while driving after a sensor has been replaced..

Perform one of the following to allow the system learn the new sensor ID:

Once the vehicle has remained stationary for more than 20 minutes, drive vehicle for a minimum of 10 minutes while maintaining a continuous speed above 15 mph (24 km/h). During this time, the system will learn the new sensor ID.
Use the TPM-RKE Analyzer, 9936, with the Scan Tool to program the WCM/SKREEM with the tire pressure sensor ID.

NOTE: If a sensor cannot be trained, see appropriate manufacturer service information.