Diagnostic Test

CHECK FOR AN ACTIVE DTC

NOTE:

Before proceeding with this diagnostic procedure, verify the Left and Right Multifunction Switch and Clockspring harness connectors are properly seated and verify proper pin terminal tension. A loose connection at any of these connectors may cause this DTC to set.

Turn the ignition on.
Activate the Rear Wiper Switch.
With the scan tool, read DTCs.
Does the scan tool display this DTC as active?

Yes
- Replace the Rear Wiper Switch in accordance with the Service Information.
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Test complete. The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.