6F24 Automatic Transmission (Service Information): Specifications: Specifications
6F24 TORQUE SPECIFICATIONS
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. | NEW FASTENER* |
|---|---|---|---|---|
| Flexplate to Torque Converter | 37 | 27 | - | |
| Flexplate to Crankshaft-M12X1.25X14.00 (Do Not Reuse Original Bolts) | 29 + 51° | 21 + 51° | - | X |
| Engine to Transaxle-M12X1.25X65.00 | 93 | 69 | - | |
| Engine to Transaxle-M10X1.25X45.00 | 50 | 37 | - | |
| Trans to Engine-M12X1.25X80.0 | 95 | 70 | - | |
| Transaxle to Engine-M12X1.25X50.0 | 93 | 69 | - | |
| Trans to Engine-M10X1.25X45.00 | 50 | 37 | - | |
| Bracket to Transaxle-M6X1.0X20.0 | 8 | - | 71 | |
| Dust Shield to Transaxle-M6X1X9.5 | 10 | - | 88 | |
| Lever to Transaxle Shaft-M8X1.25 | 19 | 14 | - | |
| ATX Cable Adjust-M5X0.8X14.00 | 8 | - | 71 | |
| Shifter to Floor Pan-M6X1.00 | 9 | - | 80 | |
| Bracket to Front Crossmember-M12X1.75X40.00 | 95 | 70 | - | |
| FEM to Lower Load Path-M10X1.25X83.0 | 45 | 33 | - | |
| FEM to Front Rail-M10X1.25X30.5 | 45 | 33 | - | |
| Isolator to Transaxle Bracket-M12X1.75X70.00 | 100 | 74 | - | |
| Isolator to Rail LT-M12X1.75X50.00 | 87 | 64 | - | |
| *NEW FASTENER: Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. | ||||
6F24 INTERNAL TORQUE SPECIFICATIONS
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. | NEW FASTENER* |
|---|---|---|---|---|
| Transfer Gear Driven | 34 | 25 | - | |
| Transfer Gear Driven Spanner Nut | 265 | 195 | - | |
| Rear Cover | 30 | 22 | - | |
| Under Driver Brake Retainer With 40HP driver | 33 | 24 | - | |
| Under Driver Brake Retainer With 45HP driver | 39 | 28 | - | |
| Under Drive Brake Chamber | 11 | - | 97 | |
| Differential Ring Gear Bolts | 120 | 88 | - | |
| Differential Case Screws | 11 | - | 97 | |
| Parking Rod Guide | 11 | - | 97 | |
| Fluid Pump Pipe | 11 | - | 97 | |
| Fluid Pump to Transaxle | 22.5 | 17 | - | |
| Fluid Pump Cover | 22.5 | 17 | - | |
| Fluid Filter | 11 | - | 97 | |
| Bell Housing | 32 | 23 | - | |
| Valve Body | 11 | - | 97 | |
| Detent Spring | 14 | - | 124 | |
| Valve Body Solenoid Retainer Screws | 10 | - | 88 | |
| Valve Body Accumulator Plate Bolts | 11 | - | 97 | |
| Valve Body Separator Plate Bolts | 6 | - | 53 | |
| Valve Body Housing Bolts | 15 | - | 97 | |
| Valve Body Cover Pan | 13 | - | 132 | |
| Oil Drain Plug | 40 | 30 | - | |
| Differential Access Hole Plug | 40 | 30 | - | |
| Trans Range Sensor (Inhibitor Switch) | 11 | - | 97 | |
| Wire Harness Retainer Screws | 10 | - | 88 | |
| Wire Harness Connector Hold Down Bolt | 10 | - | 88 | |
| Wire Harness Solenoid Connector Bolts | 10 | - | 88 | |
| Vent Bracket Bolt | 11 | - | 97 | |
| Cooler Line Bracket Bolt | 11 | - | 97 | |
| Differential Fluid Shield Bolts | 11 | - | 97 | |
| *NEW FASTENER: Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. | ||||