Charging System (Service Information): Generator: Installation: Installation

Fig 1: Generator Removal/Installation

Courtesy of CHRYSLER GROUP, LLC

1. Install the generator (1).
   Fig 2: Lower Mounting Bolt

   Courtesy of CHRYSLER GROUP, LLC
2. Install the lower bolt finger tight.
   Fig 3: Upper Mounting Bolt

   Courtesy of CHRYSLER GROUP, LLC
3. Install the upper generator mounting bolt. Tighten upper and lower bolts to 54 N.m (40 ft. lbs.).
   Fig 4: Battery Cable Connection

   Courtesy of CHRYSLER GROUP, LLC
4. Install the B+ cable. Tighten nut to 10 N.m (89 in. lbs.).
   Fig 5: Field Connection

   Courtesy of CHRYSLER GROUP, LLC
5. Connect the generator field wire harness connector.
   Fig 6: Identifying A/C Compressor

   Courtesy of CHRYSLER GROUP, LLC
7. Install the A/C compressor. Refer to COMPRESSOR, A/C, INSTALLATION .
   Fig 7: Idler Pulley Removal/Install

   Courtesy of CHRYSLER GROUP, LLC
8. Install the accessory drive idler pulley.
9. Install the serpentine belt (3). Refer to BELT, SERPENTINE, INSTALLATION .
   Fig 8: Lower Air Dam/Belly Pan

   Courtesy of CHRYSLER GROUP, LLC
10. Install the accessory drive splash shield.
11. Install the underbody air dam.
12. Install the right front wheel.
13. Evacuate and fill the A/C System. Refer to PLUMBING, STANDARD PROCEDURE .
14. Connect the negative battery cable.
    Fig 9: Air Cleaner Box And Snorkel

    Courtesy of CHRYSLER GROUP, LLC
15. Install the air inlet tube. Fasten with two screws (3).