Programming The RF-Hub

If the Remote Frequency Hub Module (RFHM) is replaced on vehicles equipped with the Passive Entry key:

1. Position the ignition to OFF
2. Activate the hazard warning lights
3. Connect the scan tool
4. Navigate to RFH control unit located in "Misc Functions" menu
5. Select and perform the "RFH control unit replacement" routine and follow the prompted instructions
6. Once complete, perform the following routines located in the "Misc Functions" menu:
   1. Write the rated front and rear tire pressure values
   2. Program ID of rear right tire sensor
   3. Program ID of rear left tire sensor
   4. Program ID of front left tire sensor
   5. Program ID of front right tire sensor
   6. Carry out the "TPM sensor roller bench test" procedure.
7. Programming is complete.