Cluster Assembly
WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
- Position the instrument cluster (1) close enough to the instrument panel to reconnect the instrument panel wire harness connectors to the connector receptacles on the back of the cluster housing.
- Position the instrument cluster mounting tabs to the mounting holes in the instrument panel armature (2).
- Install and tighten the four screws (3) that secure the mounting tabs of the instrument cluster. Tighten the screws to 2 N.m (17 in. lbs.).
- Reinstall the cluster bezel onto the instrument panel. Refer to BEZEL, INSTRUMENT CLUSTER, INSTALLATION .
- Reconnect the battery negative cable.
NOTE:
Certain indicators in this instrument cluster are automatically configured. This feature allows those indicators to be activated or deactivated for compatibility with certain optional equipment. If a problem is noted that involves improper illumination of an indicator, disconnect and isolate the battery negative cable. After about five minutes, reconnect the battery negative cable and turn the ignition switch to the ON position. The instrument cluster should automatically relearn the equipment in the vehicle and properly configure the configurable indicators accordingly.