Removal And Installation: 2.4L: Removal

Open the cover of the fuse box in the engine compartment and remove the fuse F21 (15 A) of the fuel pump.
Start the engine and run until the fuel in the lines is depleted.
Install the fuse removed earlier and close the fuse box cover.
Remove the rear seat cushion. Refer to SEAT CUSHION, REMOVAL AND INSTALLATION .

Fig 1: Fuel Pipes Access Cover & Screws
Courtesy of CHRYSLER GROUP, LLC
Lift the cover, unscrew the screws and remove the cover to access the fuel pipes (1).

Fig 2: Fuel Vapor Hoses & Clamp
Courtesy of CHRYSLER GROUP, LLC
Open the clamp and release the fuel vapor hoses (1).

Fig 3: Fuel Pump Access Cover & Screws
Courtesy of CHRYSLER GROUP, LLC
Lift the cover, unscrew the screws and remove the cover to access the fuel pump.

Fig 4: Connector, Fuel Delivery Pipe & Fuel Vapor Pipe Quick Coupling
Courtesy of CHRYSLER GROUP, LLC
Unplug the fuel pump's electrical connection (1).
Disconnect the fuel delivery pipe quick coupling (2).
Disconnect the fuel vapor pipe quick couplings (3).

Fig 5: Pump Assembly Mounting Ring Set & Special Tool
Courtesy of CHRYSLER GROUP, LLC
Mount the 2000002100 (EMEA) or (special tool #9340, SAE Fuel Pump Lock Ring Wrench) (NAFTA) tool (1a) and remove the pump assembly mounting ring set (1b).

Fig 6: Fuel Pump Assembly
Courtesy of CHRYSLER GROUP, LLC
Disconnect the quick coupling of the fuel vapor recovery pipe.

Fig 7: Fuel Pump Assembly
Courtesy of CHRYSLER GROUP, LLC
Remove the fuel pump assembly (1).

Fig 8: Tank Seal
Courtesy of CHRYSLER GROUP, LLC
Remove the seal on the tank (1).