Module, Anti-Lock Brake System (Abs): Installation
WARNING: This page is about a different car, the 2017 RAM ProMaster 3500, 2017 RAM ProMaster 2500, and 2017 RAM ProMaster 1500. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - ABM |
| 2 - HCU |
| 3 - SOLENOID VALVE STEM |
CAUTION:
Do not to touch the sensor terminals on the HCU side or the contact pads on the ABM side as this may result in contamination and issues in the future.
- Align components and install the ABM (1) on the HCU (2).
1 - MOUNTING SCREWS 2 - ABM - Install the four screws (1) attaching the ABM (2) to the HCU. Tighten the mounting screws to 3 N.m (27 in. lbs.).
1 - ABM (PART OF ICU) 2 - WIRING HARNESS CONNECTOR CAUTION:Before installing the ABM harness connector on the ABM, be sure the seal is properly installed in the connector.
- Insert the ABM wiring harness connector (2) into the socket of the ABM (1) and close the cover, locking the connector in place.
- Connect the negative cable on the battery negative post.
- Hook up the scan tool to initialize the ABM and perform the following:
- Clear any faults.
- Perform the ABS Verification Test and road test the vehicle. Refer to ABS VERIFICATION TEST .