Module, Blind Spot (BSM): Removal
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the negative cable from the battery. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector before disconnecting the negative cable from the battery.
- Reach up behind the outboard end of the rear bumper fascia to access and disconnect the wire harness connector (4) from the appropriate blind spot sensor (3) connector receptacle.
- Disengage the latch tabs (2) of the blind spot sensor mounting bracket and pull the sensor out of the bracket.