Module, Park Assist (PAM): Removal
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the quarter trim panel from the left quarter inner panel (1). Refer to PANEL, QUARTER TRIM, REMOVAL .
- Disconnect the body wire harness connectors (4) from the Park Assist Module (PAM) (3) connector receptacles on the left quarter inner panel just behind the left rear wheel house.
- Remove the two nuts (2) that secure the PAM to the weld studs on the quarter inner panel.
- Remove the PAM from the vehicle.