Sunroof And Sunshade Programming: Notes

New Replacement Motors - Sunroof and Power Sunshade -  The following procedure must be followed only when new replacement service motors are installed:

1. Press and hold the sunroof glass CLOSE switch, the glass will cycle to the vent position then slightly reverse and stop, continue to press and hold the sunroof close switch.
2. While still holding the glass CLOSE switch the power sunshade will then cycle to close position and then reverse and cycle to half open position.
3. Once the sunroof glass and power sunshade have stopped motion release the sunroof glass CLOSE switch and press and hold it again within 5 seconds.
4. The following sequence of sunroof operations will occur, do not release the switch until the operations are fully completed; the power sunshade will cycle to the full open position, sunroof glass will cycle to open position and back to closed position, power sunshade will cycle to closed position.
5. Release the switch once all operation stops; initialization and calibration of motors is complete. If the switch is released prior to full completion of the operations described express operation "one-touch" function of the sunroof and power sunshade will be disabled. The re-calibration of existing motors procedure must be followed to enable express operation.

Re-Calibration of Existing Motor - Sunroof and Power Sunshade -  The following procedure must  be followed when one of the below are true:

• Original existing motors have been removed and re-installed on the sunroof module.
• Express operation "one touch" no longer works.
• Sunroof glass or power sunshade is auto-reversing during express close operation with no obstruction blocking sunroof.

1. Press and hold the sunroof glass CLOSE switch, sunroof glass will cycle to the close position and stop, release the switch.
2. Press and hold the sunroof glass CLOSE switch again. After 10 seconds the re-calibration process will be begin.
3. When the re-calibration process begins the glass will cycle to the vent position then slightly reverse and stop, continue to press and hold the sunroof close switch.
4. While still holding the glass CLOSE switch the power sunshade will then cycle to CLOSE position and then reverse and cycle to half open position.
5. Once the sunroof glass and power sunshade have stopped motion release the sunroof glass CLOSE switch and press and hold it again within 5 seconds.
6. The following sequence of sunroof operations will occur, do not release the switch until the operations are fully completed; the power sunshade will cycle to the full open position, sunroof glass will cycle to open position and back to closed position, power sunshade will cycle to closed position.
7. Release the switch once all operation stops; re-calibration of motors is complete. If the switch is released prior to full completion of the operations described express operation "one-touch" function of the sunroof and power sunshade will be disabled. In this case the entire re-calibration procedure must be repeated.