LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2017 >> Wrangler Rubicon, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Electronic Control Modules (Service Information)) >> Module, Radio Frequency (RF Hub) >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module, Radio Frequency (RF Hub): Removal

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Pull down the rear of the headliner to gain access to the Radio Frequency Hub (RF-Hub) module. Refer to HEADLINER, REMOVAL .
  3. Disconnect both body wire harness connectors (1) (if equipped) and the antenna wire harness connector (2) (if equipped) from the RF-Hub.
    GC0176934Courtesy of CHRYSLER GROUP, LLC
  4. Remove both fasteners (1) securing the RF-Hub module to the vehicle.
  5. Remove the RF-Hub module.
scientia non olet · About LEMON Manuals