LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Electronic Control Modules (Service Information)) >> Module, Comfort Seat And Wheel (CSWM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module, Comfort Seat And Wheel (CSWM): Installation

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

The Heated Seat Module mounting tab can be damaged during module removal and installation. Use care to properly align tab to prevent binding that could result in tab breakage.

  1. Install the Comfort Seat and Wheel Module (CSWM) into the vehicle.
  2. Position the retaining tab with the mounting hole in the seat pan. Firmly apply even pressure to the module until the mounting tab is fully seated.
  3. Connect the wire harness connector to the module.
  4. Connect the battery negative cable.

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to align the PROXI configuration data into the new ECU. Follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under Body Control Module (BCM) Miscellaneous Functions menu. 

scientia non olet · About LEMON Manuals