LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Electronic Control Modules (Service Information)) >> Module, Instrument Panel Cluster >> Removal >> Cluster Assembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Cluster Assembly

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
    GC0159718Courtesy of CHRYSLER GROUP, LLC
  2. Remove the instrument cluster bezel (1). Refer to BEZEL, INSTRUMENT CLUSTER, REMOVAL .
    GC0159211Courtesy of CHRYSLER GROUP, LLC
  3. Disengage the two gap hider clips at the bottom of the instrument cluster.
  4. Remove the two upper (1) and the two lower (2) fasteners securing the instrument cluster to the instrument panel.
  5. Pull the top of the instrument cluster back and lift the instrument cluster upward to remove.
    GC0158390Courtesy of CHRYSLER GROUP, LLC
  6. Disconnect the instrument cluster wire harness connector (1) from the connector receptacle on the back of the cluster housing.
    GC0160111Courtesy of CHRYSLER GROUP, LLC
  7. Remove the instrument cluster (1) from the vehicle.
scientia non olet · About LEMON Manuals