Diagnostic Test
- CHECK IF TIPM CAN BUS DTCS ARE PRESENT
- With the scan tool, read TIPM DTCs.
Are there any TIPM CAN BUS DTCs present?
Yes
- Refer to DIAGNOSTIC CODE INDEX for diagnostic procedures and other possible causes.
- Perform NAG1 TRANSMISSION VERIFICATION TEST. Refer to NAG1 TRANSMISSION VERIFICATION TEST .
No
- Go To 2
- With the scan tool, read TIPM DTCs.
- CHECK IF ENGINE DTCS ARE PRESENT
- With the scan tool, read Engine DTCs.
Are there any Engine DTCs present?
Yes
- Refer to DTC Based Diagnostics and perform the appropriate diagnostic procedure.
- Perform NAG1 TRANSMISSION VERIFICATION TEST. Refer to NAG1 TRANSMISSION VERIFICATION TEST .
No
- Using the schematics as a guide, check the Transmission Control Module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the TCM in accordance with the Service Information.
- Perform NAG1 TRANSMISSION VERIFICATION TEST. Refer to NAG1 TRANSMISSION VERIFICATION TEST .
- With the scan tool, read Engine DTCs.