LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2018 >> Compass Trailhawk >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Electronic Control Modules (Service Information) - Mp) >> Module, Radio Frequency (RF Hub) >> Removal And Installation >> Removal And Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal And Installation: Installation

WARNING: This page is about a different car, the 2017 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the RFHM to the vehicle, then install and securely tighten the nuts.
  2. Connect the wire harness connectors to the RFHM.
  3. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
  4. Secure the headliner back in the installed position.
  5. Secure the tailgate weatherstrip.
  6. If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to align the PROXI configuration data into the new ECU. Follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under Body Control Module (BCM) Miscellaneous Functions menu.
  7. Connect the diagnostic scan tool and perform the learning procedure.
scientia non olet · About LEMON Manuals