Module, Adaptive Cruise Control: Installation: Module
WARNING: This page is about a different car, the 2015 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The molded plastic ball socket clips in the Adaptive Cruise Control (ACC) module mounting bracket MUST be removed, discarded and replaced with new ball socket clips any time the module is removed from the bracket.
- Install three new molded plastic ball socket clips into the ACC module mounting bracket (2) located below the center of the front bumper support bar (1). The clips are installed from the back side of the bracket by rotating them clockwise.
- Position the ACC module (4) to the mounting bracket.
- Align the one fixed and the two adjustable ball studs of the module with the three plastic ball socket clips in the bracket.
- Using hand pressure, press firmly and evenly on the face of the module until each of the ball studs snaps into the ball socket clips.
- Reconnect the Front End Module (FEM) wire harness connector (5) to the ACC module connector receptacle.
- If equipped, snap the module bezel (mirror cover) (3) over the face of the ACC module.
- Install the front skid plate and air dam. Refer to PLATE, SKID, FRONT, INSTALLATION .
- Check the ACC module vertical alignment. Refer to MODULE, ADAPTIVE CRUISE CONTROL, MODULE PROGRAMMING .
- Use a diagnostic scan tool and the appropriate diagnostic information to perform the horizontal module alignment procedure.