3.0L Diesel

CAUTION:

Before installing the radiator or A/C condenser, be sure the radiator-to-body and radiator-to-A/C condenser rubber air seals are properly fastened to their original positions. These are used at the top, bottom and sides of the radiator and A/C condenser. To prevent overheating, these seals must be installed to their original positions.

Courtesy of CHRYSLER GROUP, LLC

Carefully install the radiator (1) into the vehicle. Guide the two radiator rubber air seals into the lower radiator support.

Courtesy of CHRYSLER GROUP, LLC
Install the cooling fan assembly and engage both lock tabs (1).

Courtesy of CHRYSLER GROUP, LLC
Connect the cooling fan wire harness connector (1).
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .

Courtesy of CHRYSLER GROUP, LLC
Install the lower cooling fan closeout panel (1).

Courtesy of CHRYSLER GROUP, LLC
Install the lower radiator hose (1).
Remove support and lower the vehicle.

Courtesy of CHRYSLER GROUP, LLC
Install the upper radiator hose (1).

Courtesy of CHRYSLER GROUP, LLC
Carefully install the A/C condenser into the radiator mounts and engage the two retaining tabs (1 and 2).

Courtesy of CHRYSLER GROUP, LLC
Connect both of the transmission cooler lines (1).
Install the Charge Air Cooler (CAC) Refer to COOLER AND HOSES, CHARGE AIR, INSTALLATION .
Fill the cooling system. Refer to STANDARD PROCEDURE .
Install the front skid plate. Refer to INSTALLATION .
Connect the negative battery cable.
Start the engine and check for leaks.