Module, Keyless Ignition Node (Kin): Installation

WARNING: This page is about a different car, the 2018 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of CHRYSLER GROUP, LLC

Assemble the ignition node (3) to the ignition node bracket (2). Tighten using four screws (1).

Courtesy of CHRYSLER GROUP, LLC
Position and tighten (1) the ignition node and bracket to the back of the lower instrument panel trim bezel.
Connect the wiring harness connector to the connector receptacle (2) on the back of the ignition node.
Install the radio. Refer to RADIO, INSTALLATION .
Install the center dash trim bezel.
Install the lower steering column opening trim panel. Refer to COVER, STEERING COLUMN OPENING, INSTALLATION .
Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
NOTE:
If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.
If the KIN is being replaced, perform the verification test. Refer to STANDARD PROCEDURE .
NOTE:
This procedure will require you to log into DealerCONNECT and enter a PIN when requested. The PIN is temporary and will be active for 12 hours. After 12 hours, a new PIN will need to be obtained from DealerCONNECT.