LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2019 >> Renegade Trailhawk >> Repair and Diagnosis >> External Pages >> Different car >> Section 1308 (Electronic Control Modules (Service Information)) >> Module, Fuel Pump Control >> Removal And Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal And Installation: Removal

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  3. Remove the left rear splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, REMOVAL .
    GC0170087Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the body wire harness connector (2) from the Fuel Pump Control Module (FPCM).
  5. Remove the fasteners (1) that secure the FPCM to the panel.
  6. Remove the FPCM from the vehicle.
scientia non olet · About LEMON Manuals