LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2019 >> Renegade Trailhawk >> Repair and Diagnosis >> External Pages >> Different car >> Section 1308 (Electronic Control Modules (Service Information)) >> Module, Integrated Center Stack (ICSM) >> Removal And Installation >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal And Installation: Removal

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

LHD shown, RHD similar.

multimedia:A supplement to the article is available.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
    GC0189277Courtesy of CHRYSLER GROUP, LLC
  2. The tolerance between the Integrated Center Stack (ICS) and the instrument panel is very tight, so to avoid damage to the I/P the use of a feeler gauge (1) or equivalent is needed to release the ICS (2) enough to get a trim stick behind the ICS.
    GC0189871Courtesy of CHRYSLER GROUP, LLC
  3. After the trim stick (2) is inserted behind the ICS (3), release the retaining clips and partially remove the ICS.
    GC0190126Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the ICS wire harness connector (2) from the ICS (1b).
  5. Remove the ICS (1b) from the vehicle.
scientia non olet · About LEMON Manuals