Removal And Installation: 1.3L: Removal

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If this Powertrain Control Module (PCM) is being replaced with a new unit, a diagnostic scan tool MUST be used to align the PROXI configuration data into the new PCM. Follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under Body Control Module (BCM) Miscellaneous Functions menu.

Disconnect and isolate negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Remove the engine cover. Refer to COVER, ENGINE, REMOVAL AND INSTALLATION .

Courtesy of CHRYSLER GROUP, LLC
Release the upper fasteners (1a) and move the engine coolant supply reservoir (1b).
Press the lower fastener (2a) and move the reservoir (1b) outside of the working area.

Courtesy of CHRYSLER GROUP, LLC
Disconnect the Powertrain Control Module (PCM) wire harness connector (1).
Remove the fastener (2a) and disconnect the ground lead (2b) from the PCM.
Open the retainers (3) and move the battery wiring outside the working area.

Courtesy of CHRYSLER GROUP, LLC
Remove the fasteners (1a) and the PCM and shield (1b).