LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2019 >> Renegade Trailhawk >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Electronic Control Modules (Service Information)) >> Module, Keyless Ignition Node >> Removal And Installation >> Removal And Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal And Installation: Removal

WARNING: This page is about a different car, the 2015 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to align the PROXI configuration data into the new ECU. Follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under Body Control Module (BCM) Miscellaneous Functions menu.

NOTE:

For mechanical key ignition, refer to SWITCH, IGNITION, REMOVAL AND INSTALLATION .

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the instrument cluster bezel from the instrument panel. Refer to REMOVAL AND INSTALLATION .
  3. Lower the steering wheel position lever (1).
    4. Fig 1: Removing Steering Column Bottom Cover
    GC0165749Courtesy of CHRYSLER GROUP, LLC
  4. Remove the screws (2a) securing the bottom cover (2b) of the steering column.
  5. Remove the bottom cover (3a) by disengaging the retainers (3b).
    6. Fig 2: Steering Wheel Bottom Cover & Electrical Connector
    GC0163719Courtesy of CHRYSLER GROUP, LLC
  6. Disconnect the Keyless Ignition Node (KIN) wire harness connector.
  7. Remove the bottom cover (2) of the steering column.
    8. Fig 3: Ignition Push Button Switch & Mounting Screws
    GC0165811Courtesy of CHRYSLER GROUP, LLC
  8. Remove the KIN mounting screws (1).
  9. Remove the KIN (2).
scientia non olet · About LEMON Manuals