3.0L Diesel

Disconnect and isolate the negative battery cable.
Remove the front skid plate. Refer to PLATE, SKID, TRANSFER CASE, REMOVAL .
Drain the cooling system. Refer to STANDARD PROCEDURE .
Remove the Charge Air Cooler (CAC). Refer to CROSSMEMBER, RADIATOR, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Disconnect both of the transmission cooler lines (1).

Courtesy of CHRYSLER GROUP, LLC
Disengage the two retaining tabs (1) and (2), then tip the A/C condenser (4) forward and carefully remove it from the mounts and position it aside.

Courtesy of CHRYSLER GROUP, LLC
Remove the upper radiator hose (1).
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .

Courtesy of CHRYSLER GROUP, LLC
Remove the lower radiator hose (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the lower cooling fan closeout panel (1).
Remove the support and lower the vehicle.

Courtesy of CHRYSLER GROUP, LLC
Disconnect the cooling fan wire harness connector (1).

Courtesy of CHRYSLER GROUP, LLC
Release both retaining tabs (1) and pull up to remove the cooling fan assembly.
The lower part of the radiator is equipped with two alignment dowel pins and fit into rubber grommets. These rubber grommets are pressed onto the radiator.
Carefully lift up and remove the radiator from the vehicle. Be careful not to scrape the radiator fins against any other component.