Torque Specifications
TORQUE SPECIFICATIONS
| DESCRIPTION | N. m | Ft. Lbs. | In. Lbs. | COMMENT |
|---|---|---|---|---|
| Rear Drive Unit (RDU) Rear Mounting Bolt | 120 | 89 | - | - |
| Differential to RDU Bracket | 55 | 41 | - | - |
| Rear Propeller Shaft Bolts | 20 | 15 | - | Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. |
| Pump Bolts | 12 | - | 106 | - |
| Pressure Sensor | 21 | 15 | - | - |
| Bearing Plate to Intermediate Bracket Bolts | 24 | 17 | - | |
| Rear Driveshaft Bolts | 20 | 15 | - | Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. |
| Intermediate Bracket to Engine Block and Oil Pan Bolts | 65 | 48 | - | - |
| Eac Bracket to Engine | 55 | 41 | - | - |
| Heat Shield to PTU | 11 | - | 97 | - |
| Front Differential Bracket to Differential | 60 | 44 | - | - |
| Propshaft Center Bearing to Body | 10 | - | 88 | - |
| Front Halfshaft to Bearing | 200 | 148 | - | Do not reuse these fasteners. If removed, a NEW fastener must be installed and tightened to specifications. |
| Rear Halfshaft to Bearing | 175 | 129 | - | Do not reuse these fasteners. If removed, a NEW fastener must be installed and tightened to specifications. |
| PTU to Transaxle | 44 | 32.5 | - | - |
| Mounting Bracket to Engine Block | 44 | 32.5 | - | - |
| Front Differential Bracket to Isolator | 100 | 74 | - | - |
| Final Drive Gear to Differential | 163 | 120 | - | |
| Front Bearing to Knuckle | 113 | 83 | - | |
| Rear Bearing to Knuckle | 55 Plus 80° | 41 Plus 80° | - | - |
| Differential Fill Plug | 35 | 26 | - | - |
| RDU Hydraulic Fluid Cover Bolts | 6 | - | 53 | - |
1-SPEED RDM SPECIFICATIONS
| DESCRIPTION | SPECIFICATION |
| GEAR RATIO | 2.73:1 |
| RING GEAR DIAMETER | 165 mm (6.5 in.) |
| DIFFERENTIAL FLUID FILL CAPACITY | 0.89 Liters |
| HYDRAULIC FLUID FILL CAPACITY | 0.439 Liters |