Switch, Memory: Removal
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the driver door panel as necessary to access the memory seat switch (1). Refer to PANEL, DOOR TRIM, REMOVAL .
- Disconnect the wire harness connector (3) from the memory seat switch.
- Using a small flat bladed tool, gently disengage the retaining tabs (2) that secure the memory seat switch to the back of the driver door handle bezel.
- Remove the memory seat switch from the driver door handle bezel.